Do not run over cord. ground pin; if missing, replace plug before use. Do not pull vac boost by plug or cord. – International models will have different cord ends. Do not pull cord around sharp edges or – corners. 75001 (12-09)
Boost as this will minimize vacuum loss. If the primary cleaning machine does not use a 2” vacuum hose a 1 ½” hose may be used instead. Use a 1 ½” hose between Vac Boost and cleaning wand. Fig. 1 75001 (12-09)
1. Remove bottom access door and inspect for loose wires or bolts. 2. Remove any lint that may have collected on screen on top of vacuum motor. STORING VAC BOOST 1. Store in a dry place. Fig. 3 75001 (12-09)
Kleenrite can inspect the part that is suspected to be faulty or have a chance to repair it, Kleenrite will ship the requested part on a COD basis (part plus freight) or if credit has been established prior to the request the part will be shipped on an Open Account basis (part plus freight).
Page 10
Kleenrite’s control. In no event shall Kleenrite be liable for loss of use, incidental or consequential damages or any damages to persons or property.
Page 11
Kleenrite’s control. In no event shall Kleenrite be liable for loss of use, incidental or consequential damages or any damages to persons or property.