Replacing The Fuse; Technical Specifications - Omnitronic AZ-212A User Manual

If the speaker system distorts, one of the loudspeakers may be defective. Test the speaker system once
more with another amplifier. If the sound remains distorted, the speaker system should not be operated any
more in order to prevent further damage. Please contact your dealer.
If clacking sounds are heard from the speaker system, screws may have loosened due to the continuous
vibrations. The speaker system should be checked by a specialist. Especially for public use, the speaker
system should be checked before every operation so that the speaker system and the speakers in the
systems are always well fixed.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption (max.):
Fuse:
Rated power:
Program power:
Components:
Sensitivity (1 W/m):
Amplifier:
Nominal power output:
Maximum power output:
Inputs:
Outputs:
1 Line Out
Frequency-range:
Dimensions (H x W x D):
Weight:
Please note: Every information is subject to change without prior notice. 03.07.2008 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
11038973 AZ-212A
230 V AC, 50 Hz ~
300 W
T 3.15 A, 250 V
150 W RMS
300 W
12" woofer, 1" horn
93 dB
150 W RMS
300 W
XLR or balanced ¼" jack
XLR
60 Hz - 18 kHz
570 x 400 x 365 mm
20 kg
11038975 AZ-215A
230 V AC, 50 Hz ~
350 W
T 3.15 A, 250 V
200 W RMS
400 W
15" woofer, 1" horn
97 dB
200 W RMS
400 W
XLR or balanced ¼" jack
XLR
60 Hz - 18 kHz
690 x 470 x 445 mm
28 kg
36/36 00038393.DOC, Version 1.0