Control Panel - Chamberlain RollerLift CR655MYQ Installation And Operating Instructions Manual

4

CONTROL PANEL

1. Terminal Block: used for external accessories (see chart below).
NOTE: The terminal block is behind a plastic cover in the back housing. Use a small screwdriver to lever
open the plastic cover if access to the terminal block is required. All wires should be secured appropriately.
Ref Function
Push button
A
Common
B
B Common
C The Protector System
(IR Beams)
Accessory Power
D
2. DN Button: used to drive the door DOWN.
3. UP Button: used to drive the door UP.
4. P Button: used to "PROGRAM" the DOOR LIMITS (see section 13).
5. S Button: used to "SAVE" and "DELETE" the "TRANSMITTERS" (see section 20).
6. LEDs: 1. Program DOWN, and Diagnostic code indicator Number 1.
2. Program UP indicator.
3. Diagnostic code indicator Number 2.
7. Control Button: Used to activate the door when transmitters are not available. Open - Stop - Close.
8. Courtesy Light: turns on during operation and automatically turns off after a period of 3 minutes .
D
C
B
B
A
1
Colour Polarity Comment
Red
+ve
White
-ve
White -ve
TM
Grey
+ve
Green
+ve
8
DN
6
Dry contact input for push button wired wall controls.
Common terminal for push button, The Protector
TM
System (IR Beams) & accessory power.
Common terminal for push button, The Protector
System TM (IR Beams) & accessory power.
The Protector System TM
type only).
24v dc 50 mA accessory output available for a
universal receiver.
2
3 4
1
2
UP
P
3
(IR Beams) input (pulsing
5
3
S
6
7