Table of Contents
Advertisement
Caution Symbol
These labels are located near the thermal print head.
Because the thermal print head is hot immediately after printing, do not
touch it. Static electricity can damage the thermal print head. To protect the
thermal print head from static electricity, do not touch it.
This symbol is placed near the cutter.
Never touch the cutter blade, as you could injure your fingers.
This symbol is placed near the peripheral drive connector.
Do not connect this to a telephone.
This symbol label or stamp is placed near the screws securing the case or
the protective plate, which should not be opened by individuals other than
service personnel. Individuals, other than service personnel, should not
remove these screws. High voltage areas in the case can be dangerous.
WARNING
1) Do not touch the cutter blade.
• There is a cutter inside the paper outlet slot. Not only should you not put your hand in
the paper outlet slot while printing is in progress, never put your hand into the outlet even
when printing is not in progress.
• The printer cover can be opened when replacing the paper. However, since the cutter blade
is on the inside of the printer cover, be careful not to place your face or hands too close to
the cutter blade.
2) During and immediately after printing, the area around the thermal head is very hot. Do
not touch it, as you could be burned.
3) Unplug the equipment immediately if it produces smoke, a strange odor, or unusual noise
and contact your dealer for advice.
4) Never attempt to repair this product yourself. Improper repair work can be dangerous.
5) Never disassemble or modify this product. Tampering with this product may result in injury,
fire, or electric shock.
Thermal head
– 12 –
Advertisement
Table of Contents
