Others - JUKI LK1903B/BSS302 Instruction Manual

3. Others

Name of part
Needle hole guide
B
A
A=1.6 B=3.5 C=1.1
Button clamp jaw lever asm. for
thick buttons, left
Button clamp jaw lever asm. for
thick buttons, right
Work attachment, large
9.5 mm
Work attachment
(with a groove)
Bottom surface
8 mm
Work attachment
(with a recessed end)
8 mm
Part No.
D2426284Y00
C
MAZ088220BAA
MAZ088230BAA
16557704
18257006
18257105
Used when there is no gap between the wrong side of button and the needle
hole guide.
Used when there is no gap between the wrong side of button and the needle
hole guide even when the needle hole guide is replaced with the aforementioned
one. (For thick buttons)
The shape of this work attachment is the same as that of the standard type of
work attachment and has a large bottom diameter.
It is suited to large buttons of which diameter is approximately ø18 mm.
When replacing the standard work attachment with this work attachment, re-
adjust the fine positioning completion switch.
This work attachment has a bottom of which diameter is standard but is provided
with a cross groove on the bottom surface. It is suited to special-shape buttons
(such as marble buttons) which do not smoothly rotate when using the standard
attachment.
This work attachment has a bottom of which diameter is standard but has a conic
recess on the bottom surface. It is suited to the buttons, such as marble buttons,
which have protruded top faces.
34
− −
Application
Ditto