Table of Contents
Advertisement
Gas Valve Safety Shutdown Test
WARNING
!
Electrical shock hazard. Follow instructions to turn
off electric power. Failure to do so could result in
death or serious injury.
Ignition system safety shutoff device must be tested after
placing boiler in operation.
With main burners fi ring, disconnect ignition cable from
intermittent pilot control box. Gas valve should shut off
main burners. TURN OFF ELECTRIC POWER to boiler before
reconnecting ignition cable, to prevent electric shock.
Adjust Pilot Burner
Remove screw cover over pilot adjusting screw.
1.
Insert small screwdriver and adjust fl ame as needed
2.
See Figure 14 & 15. Turn screw counterclockwise
to increase fl ame, clockwise to decrease. Replace
screw cover over pilot adjusting screw.
Main Burner(S)
Main burners do not require primary air adjustment and are
not equipped with primary air shutters.
Main burner fl ames form sharp blue inner cones in softer
blue outer mantel, with no yellow. Puffs of air from blow-
ing on fl ame or stamping on fl oor will cause fl ames to turn
orange momentarily. This is not unusual. Remain still when
observing main burner fl ames. See Figure 16, Page 27 .
If fl ame appearance is not correct, check main burner
orifi ces, burner throat and fl ame ports for dust and lint
obstruction. It may be necessary to remove rollout shield
to observe main burner fl ames. Replace rollout shield after
observation.
Adjust Limit Controls
Instructions for each control are included with the controls.
Recommended Boiler Water Temperatures
Settings can be changed after you have had some idea how
the system works. Example: If your system does not give
quite enough heat in very cold weather, you can raise limit
setting to 190°F.
CHECKING AND ADJUSTING
Figure 14 - Automatic Gas Valve
Figure 15
3/8" to
1/2" in
Flame
26
- Pilot Flame Adjustment
Ignition Electrode
Advertisement
Table of Contents
