Table of Contents
Advertisement
English
5.4 Text
Press t u to select Text in the main menu, then press oK to enter. Press pq to select the disk drive you
want to watch, then press oK to enter. Press pq to select the return option to go back to the previous
menu.
When highlighting the option you select, the file information will appear on the right.
6.0 TRoUbLe sHooTinG
Before calling a service technician, review following information for possible causes and solutions for the
problem you are experiencing. If the TV does not work properly after checking it, please contact your
local service line or STRONG dealer. Alternatively you can send a support mail via our website www.
strong.tv.
Problem
No picture, no
sound
No colour
Remote control
does not work
Unorderly
It is usually caused by local interference, such as cars, daylight lamps and hair driers.
ripples on the
Adjust the antenna to minimize the interference.
picture
Blank screen in
Perhaps the TV cannot recognize the resolution set by the PC. Suggest changing
pc mode
to the best resolution or other standard resolutions of Windows system. Set refresh
rate to be 60 Hz.
Snowy dots and
If the antenna is located in the fringe area of a television signal where the signal is
interference
weak, the picture may be marred by dots. When the signal is extremely weak, it may
be necessary to install a special antenna to improve the reception.
Ignition
Black spots or horizontal streaks appear, or the picture flutters or drifts. This is
usually caused by interference from car ignition system, neon lamps, electric drills,
or other electrical appliance.
Ghost
Ghosts are caused by the television signal following two paths. One is the direct
path, the other is reflected from tall buildings, hills, or other objects. Changing the
direction or position of the antenna may improve the reception.
Radio frequency
This interference produces moving ripples or diagonal streaks, and in some case,
interference
loss of contrast in the picture. Find out and remove the radio interference source.
1. Check if the fuse or circuit breaker is working.
2. Plug another electrical device into the outlet to make sure it is working or
turned on.
3. Power plug is bad contact with the outlet.
4. Check the signal source.
1. Change the colour system.
2. Adjust the saturation.
3. Try another channel. Black-white program may be received.
1. Change the batteries.
2. Batteries are not installed correctly.
3. Main power is not connected.
1. Adjust the position and orientation of the indoor/outdoor antenna.
2. Check the connection of antenna.
3. Fine tune the channel.
4. Try another channel. Broadcasting failure may happen.
Possible solution
17
Advertisement
Table of Contents
