Table of Contents
Advertisement
Problem
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "12.00".
There is no good cooking
performance using the True
Fan Cooking PLUS function.
There is no good cooking
performance using the True
Fan Cooking PLUS function.
There is no good cooking
performance using the True
Fan Cooking PLUS function.
You want to activate the
True Fan Cooking function,
but the indicator of the Plus
Steam button is on.
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
Possible cause
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
There was a power cut.
You did not activate the
True Fan Cooking PLUS
function.
You did not fill the cavity
embossment with water.
You did not activate correct-
ly the True Fan Cooking
PLUS function with the Plus
Steam button.
The True Fan Cooking PLUS
function operates.
The temperature is too low.
There is too much water in
the cavity embossment.
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
ENGLISH
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Reset the clock.
Refer to "Activating the True
Fan Cooking PLUS func-
tion".
Refer to "Activating the True
Fan Cooking PLUS func-
tion".
Refer to "Activating the True
Fan Cooking PLUS func-
tion".
Push the Plus Steam button
to stop the True Fan
Cooking PLUS function.
Set the temperature at least
to 110 °C.
Refer to "Hints and tips"
chapter.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.
29
Advertisement
Table of Contents
