Functions - Becker Centronic SunWindControl SWC441-II Assembly And Operating Instructions Manual

MAN/AUTO Sliding Switch
When the sliding switch is set to
DOWN pushbutton commands) are executed and an alarm signal (e.g.: wind
alarm if wind sensor is integrated) given.
When the sliding switch is set to
(e.g. sun protection function, ...).
The automatic sun protection functions are interrupted if a manual operation is
executed during automatic mode. These functions are re-activated automati-
cally when the programmed threshold values are exceeded or undercut after
retraction or via switching the slide switch from "S" to "H" and back to "S".
Channel
The channel of a handheld transmitter can be programmed into one or several
receivers. One or several receivers are controlled via an individual or group com-
mand respectively.
Wind threshold control switch
This control switch allows you to set the wind threshold values (approx. 2m/s
to 22 m/s).
The wind threshold value can be set to 11 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop = Level 1: retract when wind speed is low
+ Right limit stop = Level 11: retract when wind speed is high
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold
value.
If the wind speed rises above the preset wind threshold, the sun protec-
tion system is retracted and remains closed. The sun protection sys-
tem is extended again if the wind speed remains below the preset wind
threshold for approx. 15 minutes.

Functions

, manual control commands (e.g.: UP, STOP,
, automatic control commands are executed
de
en
fr
nl
17