Table of Contents
Advertisement
VLAN MUX Connection Mode
It is similar to Default Connection in configuration. Select the interface which is a VLAN MUX mode
connection configured in WAN Service, here for example, in the following, atm1/(0_1_35) is a VLAN
MUX mode connection.
select interface(VLAN MUX mode).
Click Next to go on to next step.
Type: select the protocol, PPPoE, IP over Internet, Bridge.
Description: user-defined description.
802.1P Priority: It indicates the frame priority level from 0 (lowest) to 7 (highest), which can be used
to prioritize different classes of traffic (voice, video, data, etc). Enter the priority identification,
tagged:0-7, untagged:-1.
802.1Q VLAN ID: It is a parameter to specify the VLAN which the frame belongs. Enter the VLAN ID
identification, tagged: 0-4094, untagged:-1.
You can leave 802.1P Priority and 802.1Q VLAN ID as default setting,-1, means untagged, in this
mode, the vlan tag header will not be contained, but if you want to allow one service for the specific
vlan, here you should set the two parameters, the vlan tag header will be contained.
IPv6 for this service: check whether to enable IPv6 service.
The following steps are similar to Default Connection settings, for help turn to
Default Connection
settings.
67
Advertisement
Table of Contents
