Vivotek Supreme SD9374-EHL User Manual page 9

Status LED
Item LED status
1 Steady red
Red LED OFF
2 Steady red & Green
Steady red & Green
3 Red blinking every 0.15 sec. &
every 1 sec.
4 Red blinking every 0.15 sec. &
every 0.15 sec.
Hardware Reset
The reset button is used to reset the system or to restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the reset button with a paper clip or thin object. Wait for the Network
Camera to reboot.
Restore: Press and hold the reset button for at least ten seconds to restore system defaults.
Note that all settings will be restored to factory defaults.
MicroSD/SDHC/SDXC Card Capacity
This network camera is compliant with MicroSD/SDHC/SDXC 32GB, 64GB, and other
preceding standard MicroSD cards.
NOTE:
1. This equipment is only to be connected to PoE networks without routing to outside plants.
2. For PoE input, use only UL listed I.T.E. with PoE output.
Tips:
1. If you forget the root (administrator) password for the camera, you can restore the camera
defaults by pressing the reset button for longer than 5 seconds.
2. If DHCP is enabled in your network, and the camera cannot be accessed, run the Shepherd
utility to search the network. If the camera has been configured with a fixed IP that does not
comply with your local network, you may see its default IP 169.254.x.x. If you still cannot find
the camera, you can restore the camera to its factory defaults. The factory default is DHCP
client.
3. If you change your network parameters, e.g., added a camera via a connection to a LAN card,
re-start the Shepherd utility.
blinking every 1 sec.
LED OFF
Green blinking
Green blinking
Description
Power on and system booting
Power off
Network normal (heartbeat)
Network failed
Upgrading firmware
Restoring default
VIVOTEK
User's Manual - 9