Replacing The Oven Lamp; Removing The Oven Door - Pelgrim PFI7160 Manual

MAINTENANCE

Replacing the oven lamp

Disconnect the appliance from the mains by removing the plug from the socket
before the changing the light.
The lamp can be very hot! Use protection when removing the lamp.
The lamp in this household appliance is only suitable for illumination of this appliance.
The lamp is not suitable for household room illumination. The lamp is consumable
material and is not covered by the guarantee.
1. Unscrew the glass cover (anticlockwise) and replace the oven lamp.
▷ Fit a new lamp with the same specifications.
2. Screw the glass cover back on tightly.

Removing the oven door

To clean the inside of the oven it is possible to remove the oven door.
1. Open the oven door fully and turn the pawls back as far as they will go.
2. Close the door slowly so that the clips are in the flanges (in which the pawls fit).
3. At approximately 15° (relative to the closed door position) lift the door slightly upwards and
lift it out of both hinge holders.
Assemble the door.
1. Insert the door at an angle of 15° in the hinges on the front of the appliance and push the
door forwards and downwards so that the hinges slide into their notches.
▷ Check to be sure the hinge notches are properly in place.
2. Then open the door fully and turn the pawls back to their initial position.
3. Close the door slowly and check that it closes properly.
If the door does not open or close properly, make sure the hinge notches are positioned
▷
correctly in the hinge holders.
EN 17