Replacing The Oven Lamp; Removing The Oven Door - Pelgrim PFI7160WIT/P01 Manual

MAINTENANCE

Replacing the oven lamp

Before replacing the oven lamp, switch off the appliance by removing the plug
from the socket or switching off the fuse in the fuse box. Allow the appliance to
cool down. Wear hand protection when removing the lamp.
The appliance contains a light source of energy efficiency class G.
1. Unscrew the glass cover (anticlockwise) and replace the oven lamp.
Fit a new lamp with the same specifications (230 V, 15-25 Watt, type E14, resistant to 300 °C).
2. Screw the glass cover back on tightly.
The lamp in this household appliance is only suitable for illumination of this appliance.
The lamp is not suitable for household room illumination. The lamp is consumable
material and is not covered by the guarantee.

Removing the oven door

To clean the inside of the oven it is possible to remove the oven door.
1. Open the oven door fully and turn the pawls back as far as they will go.
2. Close the door slowly so that the clips are in the flanges (in which the pawls fit).
3. At approximately 15° (relative to the closed door position) lift the door slightly upwards and
lift it out of both hinge holders.
Assemble the door.
1. Insert the door at an angle of 15° in the hinges on the front of the appliance and push the
door forwards and downwards so that the hinges slide into their notches.
Check to be sure the hinge notches are properly in place.
▷
2. Then open the door fully and turn the pawls back to their initial position.
3. Close the door slowly and check that it closes properly.
If the door does not open or close properly, make sure the hinge notches are positioned
▷
correctly in the hinge holders.
EN 17