Chapter 1 0 Static Multicast; Static Multicast Filter; Static Multicast Screen - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
This chapter describes the Static Multicast screen.

10.1 Static Multicast Filter

Use the static multicast filter to allow incoming frames based on multicast MAC
address(es) that you specify. This feature can be used in conjunction with IGMP
snooping to allow multicast MAC address(es) that are not learned by IGMP
snooping. Use the static multicast filter to pass routing protocols, such as RIP
and OSPF.

10.2 Static Multicast Screen

Click Advanced Application and then Static Multicast in the navigation panel to
display the
Static Multicast screen as shown next.
Figure 43
The following table describes the related labels in this screen.
Table 30
LABEL
The Number Of This is the number of static multicast filters configured on the MSAP2000 AAMS.
Static Multicast
Page X of X
Previous/Next
Reload
Static Multicast
Static Multicast
DESCRIPTION
This identifies which page of information is displayed and the total number of pages
of information.
Click one of these buttons to show the previous/next screen if all status
information cannot be seen in one screen.
Click this button to refresh the screen.
C
H A P T E R
Static Multicast
94
10