Table of Contents
Advertisement
MSAP2000 AAMS User's Guide
The following table describes the labels in this screen.
Table 6
LABEL
System up Time
The following fields are related to the Ethernet ports.
ENET
Port Name
Media
Duplex
Up Time
The following fields are related to the ADSL ports.
xDSL
Status
Mode
Up/Down stream
Interleave/Fast
Up Time
The following fields and buttons apply to the whole screen.
Poll Interval(s)
Stop
Clear Counter
5.2.1 Ethernet Port Statistics
In the Home screen, click an Ethernet port's number to display that port's
statistics screen as shown next.
Home
DESCRIPTION
This field shows how long the system has been running since the last time it
was started.
This field displays the number of the Ethernet port. Click a port number to
display that port's statistics screen (refer to 9.2.1).
This field displays the name of the Ethernet port.
This field displays the speed and the type of media that this Ethernet port is
using for a connection (100copper or 10copper). "-" displays when the port is
disabled or not connected.
This field displays whether the port is using half or full-duplex communication. "-"
displays when the port is disabled or not connected.
This field shows the total amount of time in hours, minutes and seconds the
port's connection has been up. "--:--:--" displays when the port is disabled or
not connected.
This identifies the ADSL port. Click a port number to display the ADSL Port
Statistics screen (refer to
This field shows whether the port is connected (Up) or not (Down).
This field shows which ADSL operational mode the port is set to use. "-
" displays when the port is not connected.
This field shows the number of kilobytes per second that a port is set to
transmit and receive.
This field shows the port's ADSL latency mode (fast or interleave).
This field shows the total amount of time in hours, minutes and seconds the
port's connection has been up. "-" displays when the port is not connected.
The text box displays how often (in seconds) this screen refreshes. You
may change the refresh interval by typing a new number in the text box
and then clicking Set Interval.
Click Stop to halt system statistic polling.
Select a port from the Port drop-down list box and then click Clear
Counter to erase the recorded statistical information for that port.
Section 6.2.2 on page
42
67).
Advertisement
Table of Contents
