Line Rate Information - ZyXEL Communications Multi-service Access Platform MSAP2000 User Manual

MSAP2000 AAMS User's Guide
Table 21
LABEL
Index
Name
Delete
Name
Start IP
End IP
Add
Cancel

7.16 Line Rate Information

Click Basic Setting and then Line Data in the navigation panel to open the
following screen. This screen displays an ADSL port's line operating values.
Information obtained prior to training to steady state transition will not be valid or
will be old information.
Figure 36
IGMP Filter Profile (continued)
DESCRIPTION
This is the number of the IGMP filter profile. Click a profile's index number to
edit the profile. You cannot edit the DEFVAL profile.
This name identifies the IGMP filter profile.
Select the Delete check box and click Delete to remove an IGMP filter profile.
You cannot delete the DEFVAL profile.
Type a name to identify the IGMP filter profile (you cannot change the name of the
DEFVAL profile). You can use up to 31 ASCII characters; spaces are not allowed.
Enter the starting multicast IP address for a range of multicast IP addresses to
which you want this IGMP filter profile to allow access.
Enter the ending multicast IP address for a range of IP addresses to which you
want this IGMP filter profile to allow access.If you want to add a single multicast
IP address, enter it in both the Start IP and End IP fields.
Click Add to save your changes to the MSAP2000 AAMS's volatile memory.
The MSAP2000 AAMS loses these changes if it is turned off or loses power, so
use the Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to start configuring the screen again.
Line Rate Information
78