Chapter 8 Security Settings; Client Filter Settings - Comtrend Corporation ER-5845n User Manual

Chapter 8 Security Settings

8.1 Client Filter Settings

You can enable client filter to control LAN computers' access to some ports of the Internet。
Filter Mode: You can select either "Permit only" or "Forbid only".
Access Policy: Select one number from the drop-down list.
Remark: A simple description of the configured file. You can also leave it blank.
Start/End IP: Enter the start/end IP address.
Port: Enter the controlled TCP/UDP protocol port. You can specify a port or port
range.
Type: Select one protocol (TCP/UDP/Both) from the drop-down list.
Time: Select the time range of client filter.
Date: Select the day(s) to run the access policy.
Enable: To enable/disable the access policy (forbid/permit the packets matched with
the access policy to pass through the router.
Example1 Forbid LAN computers at the IP addresses of 192.168.0.100--192.168.0.120 to
access the Internet.
Example 2 Permit LAN computer with the IP address of 192.168.0.145 to access
websites during 8:00 to 18:00 from Sunday to Saturday.
29