Figure 17-1 Telnet In Menu 24.5 - ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 User Manual

Please note that terms "download" and "upload" are relative to the computer. Download means to transfer
from the Prestige to the computer, while upload means from your computer to the Prestige.
Follow the instructions as shown in the next screen.
To transfer the configuration file to your workstation, follow the procedure
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current router configuration to
your workstation.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your router manual.
17.2.1 Using the FTP Command from the DOS Prompt
Step 6. Launch the FTP client on your computer.
Step 7. Enter "open", followed by a space and the IP address of your Prestige.
Step 8. Press [ENTER] when prompted for a username.
Step 9.
Enter your password as requested (the default is "1234").
Step 10. Enter "bin" to set transfer mode to binary.
Step 11. Use "get" to transfer files from the Prestige to the computer, for example, "get rom-0
config.rom" transfers the configuration file on the Prestige to your computer and renames it
"config.rom". See earlier in this chapter for more information on filename conventions.
Step 12. Enter "quit" to exit the ftp prompt.
Firmware and Configuration Maintenance
Menu 24.5 - System Maintenance - Backup Configuration
Press ENTER to Exit:

Figure 17-1 Telnet in Menu 24.5

17-3