Setup - Omron E5EK-T Manual

E5jK-T

Setup

Note: Always turn OFF the power supply to the Digital Controller before changing any switch settings.
Settings (E5AK/E5EK)
On a standard model, set up the Output Units for control outputs 1
and 2 before mounting the Controller.
On a position-proportional model, the Relay Output Unit is already
set. Therefore, this setup operation is unnecessary. (Do not replace
with other Output Units.)
When setting up the Output Units, draw out the internal mechanism
from the housing and insert the Output Units into the sockets for
control outputs 1 and 2.
E5AK
Draw-out
When drawing out the internal mechanism from the housing, pre-
pare a Phillips screwdriver matched to the size of the screw on the
lower part of the front panel.
1. Press down on the hook on the top of the front panel, and turn
the Phillips screwdriver to the left to loosen the screw on the
lower part of the front panel.
2. Draw out the internal mechanism towards you holding both
sides of the front panel.
Setting Up the Output Unit
Before Setup
Check the type of the Output Unit you are about to set up.
Procedure
1. Check the positions of the sockets you are about to insert the
Output Units into as shown in the following diagram.
OUT1
OUT2
Bracket
Hook
2. Insert the Output Unit for control output 1 into the socket
"OUT1" and the Output Unit for control output 2 into the
socket "OUT2."
3. Fasten the Output Units with the bracket (accessory).
Setting Up the Option Unit
Before Setup
Check the type of the Option Unit you are about to set up.
Procedure
1. Remove the power board and option boards in the order
shown in the following diagram.
2. Insert the Option Units into the sockets for options 1 to 3. The
following diagram shows the relationship between the Option
Units and mounting positions.
3. Mount the Option Boards and the power board in the order
shown.
E5jK-T
13