Troubleshooting - Yamaha HTR-5920 Owner's Manual

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit to the standby mode, disconnect the power cable, and contact the
nearest authorized YAMAHA dealer or service center.
General
Problem
This unit fails to turn The power cable is not connected or the
on when STANDBY/
plug is not completely inserted.
ON (or POWER) is
The protection circuitry has been
pressed, or enters the
activated.
standby mode soon
after the power has
been turned on.
This unit has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
No sound Incorrect input or output cable
connections.
The input mode is set to DTS or
ANALOG.
No appropriate input source has been
selected.
Speaker connections are not secure.
The volume is turned down.
The sound is muted.
The input mode is set to ANALOG while
playing a source encoded with a DTS
signal.
Signals this unit cannot reproduce are
being received from a source component,
such as a CD-ROM.

TROUBLESHOOTING

Cause
Connect the power cable firmly.
Make sure all speaker wire connections on this unit
and on all speakers are secure and that the wire for
each connection does not touch anything other than
its respective connection.
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds, then use
it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Select AUTO.
Select an appropriate input source with
INPUT l / h on the front panel (or the input
selector buttons on the remote control).
Secure the connections.
Turn up the volume.
Press MUTE on the remote control.
Set the input mode to DTS.
Play a source whose signals can be reproduced by this
unit.
TROUBLESHOOTING
Remedy
Refer to
page
—
11, 12
—
13-16
21
20
11
—
21
21
—
33