After hanging the hood on the bracket , remove the Alu Filters , mark 2 holes
After hanging the hood on the bracket, remove the grease filters, mark 2 holes
inside the hood for safety screws .After marking , remove the hood ,drill two holes
inside the hood for safety screws. After marking, remove the hood, drill two holes
and insert 2 pcs of Wall Plugs and finally fix the safety screws with
2 screws ST4x30mm.
and insert 2 wall plugs and finally fix the safety screws with 2 screws (ST4x30mm).
Exhaust pipe
Cooker hood
Fix the one-way-valve to the air outlet of the cooker hood. Then, attach the exhaust
Fix the one-way-valve to the air outlet of the cooker hood. Then, attach the exhaust
pipe onto the one-way-valve as shown below.
pipe onto the one-way-valve as shown below.
Exhaust pipe
Exhaust pipe
Cooker hood
Cooker hood
Chimney installation.
Chimney installation
Place the upper chimney into lower chimney,Use 2 pcs ST4x8mm screws to attach
lower and upper chimney together.
Place the upper chimney into lower chimney, use 2 pcs ST4x8mm screws to attach
Before attaching the bracket to the chimney,decide the location of lower
lower and upper chimney together.
chimney bracket fixing holes for fixing the lower chimney bracket in the later steps.
Before attaching the bracket to the chimney, decide the location of lower chimney
Noted: Do not fasten screws too much, make sure upper chimney can be
bracket fixing holes for fixing the lower chimney bracket in the later steps.
telescopically adjusted after assembled.
NOTE:
Do not fasten screws too much, make sure upper chimney can be telescopically
adjusted after assembled.
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
12
Instruction manual CCH
12
Instruction manual CCH
CCH_v3.indd 12
6
6
23/07/2018 16:17