Table Of Contents - Yamaha MV12 Owner's Manual

2
MV12/6
Features
• The MV12/6 offers 12 input channels that can be mixed into stereo,
monaural, or to four group outputs.
• A MONITOR jack offers easy connection to a sub amp for monitor-
ing. It allows monitoring of the main stereo output, TAPE IN input
and the signals from groups 1-2, 3-4.
• The mixer is equipped with a highly efficient, built-in digital effects
section. The built-in effects allow you to create professional sounding
mixes without the need of additional equipment. An EFFECT SEND
jack is also supplied to allow the use of external effectors.
• Two AUX SEND/RETURN jacks are provided. Two separate AUX
buses can be used as sends for external effectors or a monitor system.
• The mixer supplies phantom power to provide easy connection of
condenser microphones that require an external power source.
• The mixer is equipped with INSERT IN, INSERT OUT jacks for
input channels 1-4 allowing individual effects to be inserted into
individual channels.
• Input Channels 1-8 are equipped with XLR type input jacks. A three-
way selector switch allows compatibility with a wide range of sources
such as condenser microphones that need an external power source,
regular dynamic microphones, line level devices, etc.
Input Channels 9-12 are equipped with stereo line input jacks
• The main input and output jacks are also equipped with Euro-block
connectors. These connectors facilitate the installation of the mixer
as a permanent fixture in halls, etc.
• TAPE IN jacks and REC OUT jacks offer easy connection of tape
decks for playback and recording.
Caution: When the unit is installed in a rack
MV12/6 - Owner's Manual
Contents
Front & Rear Panels
Channel Control Section ........................ 3
Master Control Section .......................... 5
Connector Panel .................................... 7
About the Accessories
Applications
Supplement
Specifications ....................................... 14
Dimensions .......................................... 16
Block and Level Diagrams .................... 17
The main unit's power switch is located on the rear panel of
the unit. When installed in a rack, please use the external
power switch on a power distributor, etc.
Power distributor, etc.
............................ 3
...................... 11
.......................................... 12
.......................................... 14