Yamaha MV12 Owner's Manual page 12

10
Front & Rear Panels
I Changing the connector panel's location.
The mixer allows attachment of the connector panel to either the rear or to the top-side of the mixer to provide
optimum location of the connectors when installing the unit.
The connector panel is attached on the rear of the unit when it is shipped from the factory.
Remove the screws as shown in the illustration to change the location to the top-side.
I Attach a protector cover
Use the nine screw holes located on the control panel to attach a protector cover as shown below.
Please use M4 diameter screws with a length of 12mm or less.
Less than
12mm
M4 Diameter
MV12/6 — Owner's Manual
Please do not perform this operation yourself.
Less than 10mm 8
Control Panel
190 226 8
Units: mm