Applications - Yamaha MV12 Owner's Manual

12

Applications

Applications
Example 1) Basic Setup
Monitor Speakers
Power Amplifier
Headphones
PHONES
Set the POST Switch to "?"
(AUX2=PRE).
GROUP, ST Select Switches
Channel Faders
Procedure
q Connect line input devices or microphones to the INPUT jacks and connect a power amp, that is
connected to the main speakers, to the ST OUT Jacks.
w Use the GAIN Control on each channel to adjust the level of the input signal from the device or
microphone that is connected to the input channel (refer to page 3), and use the Channel Fader to
adjust the level of the output signal that is sent to the Master Section. Basically, you should set the
Channel Fader close to the "0" position.
e Press each channel's "ST" GROUP, ST Select Switch.
r Use the ST Master Fader to adjust the level of the signal sent to the power amplifier. Basically, you
should set the Master Fader close to their "0" position.
t Use the volume control(s) on the power amp to adjust the volume of the speakers.
If necessary, use a monitoring device (a pair of headphones, monitor speakers, etc.).
MV12/6 — Owner's Manual
Effector
INSERT
OUT
AUX 1 AUX 2 (PRE)
SEND SEND
INPUT
Microphone, Line Input
Main Speakers
Power Amplifier
INSERT
IN
ST OUT
MONO OUT
GROUP 1-4 Faders
Sub Woofer, etc.
Power Amplifier
CD Recorder, DAT, etc.
TAPE IN
REC OUT
PHONES/MONITOR Output and
Meter Select Switch
ST Master Fader