Channel Fader - Yamaha MV12 Owner's Manual

4
Front & Rear Panels
y EFFECT Control
Controls the level of the signal sent from each channel to the EFFECT bus.
This control is located after the channel fader so its level will also be affected by the channel fader
setting.
When a stereo channel is used, L and R channel signals are combined and sent to the EFFECT bus.
u PAN Control (CH1-8)
BAL Control (CH9-12)
The PAN control knobs set the position within the stereo field of each signal that is sent to the GROUP
bus 1-2, GROUP bus 3-4 and STEREO bus L-R.
The BAL control knobs set the balance between left and right channels and assigns the signals that are
received at INPUT L (CH9, 11) to GROUP buses 1/3 or STEREO bus L, and the signals received at
INPUT R (CH10, 12) to GROUP buses 2/4 or STEREO bus R.
i GROUP, ST Select Switches
Used to send the signal of each channel to the GROUP bus 1-2, GROUP bus 3-4 and STEREO bus L-R.
When the switch is ON (>), the signal is sent to the relative bus.
o Channel Fader
Controls the output level of the input channel signal and adjusts the volume balance between channels.
* Levels of unused faders should be lowered.
CH INPUT
1~4ch
CH INPUT
5~8ch
ST INPUT
9/10ch, 11/12ch
[-34~+10dB]
MV12/6 — Owner's Manual
MIC(+48V)
MIC
LINE
INPUT
[-60~+10dB]
PAD HA
GAIN
INSERT OUT [-60dB~-16dB]
[-34dB~+10dB]
[0dB]
INSERT IN
BA
[0dB]
MIC(+48V)
MIC
LINE
INPUT
[-60~+10dB]
PAD HA
GAIN
[-60dB~-16dB]
[-34dB~+10dB]
[0dB]
HA
L GAIN
[-34dB~+10dB]
HA
R
+48V
PEAK
[0dB]
[0dB]
BA
3-Stage EQ
Ch.Fader
[-10dB]
+48V
PEAK
[0dB]
[0dB]
BA
3-Stage EQ
Ch.Fader
[-10dB]
[0dB]
BA
3-Stage EQ
ST Ch.Fader
PEAK
[-10dB]
BA
3-Stage EQ
SUM
[0dB]
1-2
PAN
3-4
ST
[-6dB]
AUX1
AUX2
POST
EFFECT
[0dB]
1-2
PAN
3-4
ST
[-6dB]
AUX1
AUX2
POST
EFFECT
[0dB]
1-2
3-4
BAL
ST
[-6dB]
AUX1
AUX2
POST
EFFECT