Front & Rear Panels; Channel Control Section - Yamaha MV12 Owner's Manual

Front & Rear Panels

Channel Control Section

Channels 1-8
(Monaural)
r
Channels 9-12
(Stereo)
q
w
e
r
t
y
u
i
o
q GAIN Control
Adjusts the input level of the signal entering the mixer to an
optimum level.
To obtain an optimum balance between the S/N ratio and
dynamic range, adjust the level so that the PEAK Indicator w
occasionally lights.
-60 to -16 indicates the MIC input adjustment level, -34 to +10
indicates the LINE input adjustment level.
* The Input Select Switch located on the Connector Panel provides
settings for the type of mic or device that is connected to the INPUT
jack (refer to page 7).
w PEAK Indicator
The indicator detects peaks in the signal after it has passed the
EQ.
The indicator will light red when the level reaches +17dB to
warn that clipping is imminent.
e Equalizer
Provides +/-15dB of control over high, mid and low frequency
t
ranges at the center frequencies listed below.
HIGH :
MID
LOW :
Frequency response will be flat when the knob is positioned at
"G".
+20
+15
+10
+5
i
0
–5
–10
–15
–20
20
r AUX1, AUX2 Controls
t POST Switch
Individually controls the level of the signal sent from each
channel to the AUX1 and AUX2 buses.
The signal taken from before the channel fader is sent to
AUX1.
Depending upon the POST switch setting, the signal taken
from either before (POST Switch = ?) or after (POST Switch
= >) the channel fader is sent to AUX2.
When a stereo channel is used, L and R signals are combined
and sent to the AUX1 and AUX2 buses.
Front & Rear Panels
10kHz (shelving)
: 2.5 kHz (peaking)
100Hz (shelving)
100 1k
Frequency [Hz]
MV12/6 — Owner's Manual
3
10k 20k