Kraus Nolen KPF-1673 Installation Manual page 9

Step 6. Connect waterlines
Step 7. Flush spray hose
5
1
Step 8. Check for leaks
8
12
Connect waterlines to hot and
cold copper lines (8). Connect
waterlines (12) to angle
stops. Tighten both ends of
waterlines with a wrench
until snug. Turn on hot and
cold angle stops and check
for leaks.
NOTE: Check the filter washer in the
waterlines before connecting to the
angle stops.
Remove spray head (1) from
spray hose (5). Hold tip of
spray hose (5). Turn faucet on
and let the water run for 60
seconds to ush any debris
NOTE: Please make sure washer (11) is
installed attaching spray head to hose.
Check for leaks at the
connections. Retighten if
necessary.
.
9