Yamaha Electone EL-57 Owner's Manual page 66

If you make a mistake during recording:
1 . Press the PLAY button while the M.D.R. is still running.
This stops the recording and returns you to the starting
point of the song.
The letters "rE" (retry) appear on the left side of the LED
display and the PLAY and CUSTOM PLAY LEDs start
flashing, indicating that you can re-record the song.
2 . Press PLAY again to begin re-recording the song.
Re-recording starts from the beginning of the song and
replaces the previously recorded performance with the
newly recorded performance.
When you finish playing, press the STOP button.
7
After the small bars flash to draw a square on the
LED display to indicate the processing for stop, both
the RECORD and PLAY lamps go out, and recording
is stopped.
6
To hear your newly recorded performance, press the
8
PLAY button.
Play back will begin after a couple of seconds. For
more information on playback and other playback-
related functions, see page 69.
62
RECORD PLAY
UPPER LOWER PEDAL CONTROL UPPER LOWER
SONG FROM TO
REPEAT SONG COPY
PAUSE STOP PLAY SONG SELECT RECORD
– TEMPO + FORMAT
MUSIC DISK RECORDER
RECORD
UPPER LOWER PEDAL CONTROL UPPER LOWER
SONG FROM TO
REPEAT SONG COPY
PAUSE STOP PLAY SONG SELECT
– TEMPO +
MUSIC DISK RECORDER
Be sure to remove the floppy disk from the disk
drive after the STOP lamp lights up.
NOTE:
When the available memory reaches "008" or less,
the numbers begin flashing to warn you. If this
happens, stop recording before the display reaches
"000."
Never attempt to press the eject button or turn the
power off during recording, reading and playing
back. Doing so can damage the disk and possibly
the disk drive. Be sure to remove the floppy disk
from the disk drive before turning off the power.
PEDAL CONTROL SHIFT
SONG DEL.
CUSTOM PLAY
PLAY
PEDAL CONTROL SHIFT
SONG DEL.
RECORD CUSTOM PLAY
FORMAT