Yamaha Electone EL-57 Owner's Manual page 23

Press one of the Data Control buttons that corresponds to voice
you wish to select.
The selected voice will be shown at the upper row of the LCD.
In this case, Pop Organ appears.
(If necessary) select a voice from the Lead Voice, following steps
#1 and #2 above.
Set the volume for each voice section. There are two volume
controls: Coarse and Fine.
Coarse: Use the VOLUME controls of each voice section on the
panel to set the desired level for each voice. The controls have
seven volume settings, from a minimum of 0, or no sound, to a
maximum of full volume.
UPPER KEYBOARD VOICE
STRINGS BRASS CLARI- SAXO-
NET PHONE
ORGAN PIANO GUITAR VIBRA-
PHONE
Fine: Pressing the same panel voice button again (or the same
Data Control button corresponding to the selected voice) calls
up the Voice Condition display. Use the Data Control buttons
directly under the display to change the level of the desired
voice. The relative level is indicated by the bar under each voice
in the display as well as by a numeric value (from 0-24).
VOLUME
MAX
1
CHORUS HARMO-
NICA
COSMIC TUTTI 2
MIN
NOTE:
Pressing a voice button once calls up
that voice's Voice Menu display.
Pressing it a second time calls up the
Voice Condition display. Successive
presses alternate between the two
displays.
2
19