Voltage Selector - Yamaha Clavinova CLP-120 Owner's Manual

3.
Mount the main unit.
CAUTION
• Fingers can become pinched between the main
unit and the rear or side panels, be extra careful
so as not to drop the main unit.
• Do not hold the keyboard in any position other
than the position shown in the illustration.
Be sure to place your hands at least 10 cm
from either end of the main unit when positioning it.
At least
10 cm
4.
Fix the main unit.
(1) Center the main unit to pro-
duce equal clearance on
the left and right sides.
58 CLP-120: Keyboard Stand Assembly
CLP-130/120
(2) Use 6x16 mm short screws
2 to secure the main unit
from the front.
5.
Connect the pedal cord.
(1) Insert the pedal cord plug to the
pedal connector from the front.
(3) Use a vinyl tie
to take up any
slack in the
pedal cord.
(2) Attach the cord holders to
the rear panel as shown,
then clip the cord into the
holders.
6.
Set the voltage selector and connect the
power cord.
127
240

Voltage Selector

Before connecting the AC power cord, check the setting
of the voltage selector which is provided in some areas.
To set the selector for 110V, 127V, 220V or 240V main
voltages, use a "minus" screwdriver to rotate the selector
dial so that the correct voltage for your region appears
next to the pointer on the panel. The voltage selector is
set at 240V when the unit is initially shipped. After the
proper voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A plug
adaptor may be also provided in some areas to match the
pin configuration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious
damage to the Clavinova or result in improper
operation.