Clp-120: Keyboard Stand Assembly - Yamaha Clavinova CLP-120 Owner's Manual

CLP-120: Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready.
Remove the following parts from the package.
Assembly Parts
6 × 25 mm long screws ×4
1
6 × 16 mm short screws ×4
2
4 × 12 mm thin screws ×2
3
Main unit
Side
panel Rear panel
(left)
Pedal box
Bundled pedal
cord inside
A headphone hanger is included in the CLP-120 package.
You can attach a headphone hanger on the Clavinova to
hang the headphones (page 12).
4 × 20 mm tapping screws ×4
4
Cord holders × 2
Side
panel
(right)
AC power cord
TIP
1.
Attach the side panels to the pedal box.
Side panel
(left)
(1) Untie and straighten
out the bundled cord
(2) Use the four 6×25 mm long
attached to the bot-
tom of the pedal box.
Don't discard the
vinyl tie, you'll need it
later in step 5.
2.
Attach the rear panel.
(1) Place the bot-
tom edges of the rear
panel on the feet's pro-
truding edges, with the
panel slightly angled
as shown in the illus-
tration.
Then, align the top part
of the panel with the
side panels.

CLP-120: Keyboard Stand Assembly

CLP-130/120
Side panel
(right)
screws 1 to attach the
pedal box. First attach one
side panel, then attach the
other side panel.
(2) Secure the top of the
rear panel to the side
panel brackets using two
4×12 mm thin screws 3.
(3) Secure the bottom
of the rear panel to
the pedal box using
four 4×20 mm tap-
ping screws 4.
57