Table of Contents
Advertisement
802.11AC Wireless Access Point
Installation Manual
3.2 Checking before Installation
Please check the following items before the AP installation:
Please power to the AP first and connect the AP to the Ethernet, then check the
LED status to make sure the AP can work normally.
Please ensure to complete the wiring in the position of AP installation.
WL8200 series indoor AP supports 802.3af and 802.3at standard PoE (Power
over Ethernet) power. If user wants to get the maximum performance, user can
use the 1000M connection method.
Please record AP's MAC address and serial number (MAC address and serial
number are on the back of the AP) first for convenient to find and use.
3.3 Ensure the Installation Position
The rules of installation position are as below:
Cut back the obstacles (such as walls) between AP and the user terminal device
as much as possible.
Make the AP's position far away from the electrical device that can bring the RF
noise (such as the microwave).
The installation position should be hidden as much as possible to prevent
disturbing the inhabitants.
Strictly forbid to install the AP in the environment with hydrocephalus, seepage,
water-clock and condensation. And user should avoid the water flowing into the
device along the cable.
If there is outdoor cable, please check if installed the network port SPD beside the AP,
the network port SPD should be provided by user.
3.4 Install WL8200 Series
WL8200 Series can be installed indoor only and there are two methods supported:
Wall hanging installation
T-keel installation
3.4.1 Wall Hanging Installation
If install the AP on the wall, use the supporting expansion screw tubes and screws of
the wall mounting. After received the device, the expansion screw tubes and screws as
below in the accessory bag can be found.
Chapter 3 AP Installation
3-2
Advertisement
Table of Contents
