Local Power; Checking After Power - Digitalchina Networks WL8200 Series Installation Manual

802.11AC Wireless Access Point
Installation Manual
User can use the Ethernet cable to connect the Ethernet interface of the AP and the
switch which supports PoE function to power to the AP.
WL8200 series adopts the 802.3af/802.3at PoE power supply. When the USB is not
used, it adopts the 802.3af PoE power supply; if the USB is used, it should adopt the
802.3at PoE power supply. The device provides two Ethernet interfaces of LAN1 and
LAN2. Only LAN1 provides PoE power function as below. The marks of the two interfaces
are LAN1 and LAN2 respectively. When the network cable is plugged in, please plug the
PoE cable in the LAN1.

3.5.3 Local Power

WL8200 series can also adopt the power adapter for power supply. The power
adapter uses 12V DC power and please ensure if the adapter is chosen correctly before
powering on.
The power adapter and the power cord are not provided; user should choose to buy
them.
Items
power adapter input
power adapter output

3.5.4 Checking after Power

Check if the LED of AP works normally after connecting the power. The explanation of
LED status is seen in the product spec.
Fig 3-8 POE power supply interface
Table 3-1 power adapter specifications
100-240V AC
+12V
3-6
Chapter 3 AP Installation
Explanation
2A