Table of Contents
Advertisement
802.11AC Wireless Access Point
Installation Manual
When installed with wall hanging method, please connect the Ethernet cable to the
AP first and then install the AP on the wall mounting bracket.
(1) Connect the AP to the wired LAN by using the cable
(2) Mark the positions of two holes on the wall and the distance between them is 65
mm. And then punch two holes with the impact drill;
(3) Insert the expansion bolt into the holes and use the rubber hammer beating it until
the expansion bolt got into the wall completely;
(4) Screw the screws in the two plastic expansion screw tubes. Please do not screw
them in the tubes completely, keep 3-5 mm out of them;
(5) Make the two holes on the back of the AP hang on the two screws;
(6) After hanging the AP, push the AP down and the AP will be locked on the wall. The
installation steps are as below:
Punch and nail on the wall
3.4.2 T-keel Installation
Fig 3-2 wall mounting screws
Stuck the AP on the screws
Fig 3-3 steps of wall hanging installation
3-3
Chapter 3 AP Installation
Complete the installation
Advertisement
Table of Contents
