Table of Contents
Advertisement
Removing and replacing parts
Use the removal and replacement procedures when you repair, maintain, or exchange the parts in the
®
IBM Power
System E880C (9080-MHE), IBM Power System E870C (9080-MME), IBM Power System E880
(9119-MHE), or IBM Power System E870 (9119-MME) server.
Problems on your managed system are reported to the management console as serviceable events. You
can view the problem, manage problem data, report the event to your service provider, or repair the
problem. On a regular basis, review and close any open serviceable events that have been repaired on the
management console.
To repair a problem by using the Hardware Management Console, see Repairing a part by using the
HMC(http://www.ibm.com/support/knowledgecenter/POWER8/p8haj/p8haj_hmc_repair.htm). If you
were sent to this procedure from another procedure to replace a specific part, see Exchange
FRU(http://www.ibm.com/support/knowledgecenter/POWER8/p8ha1/smexchangefru.htm).
Removing the time-of-day batteries at the end of life of your server
Learn how to remove the time-of-day batteries from the IBM Power System E880C (9080-MHE), IBM
Power System E870C (9080-MME), IBM Power System E880 (9119-MHE), or IBM Power System E870
(9119-MME) server at the end of life of your server.
The time-of-day batteries must be removed and recycled or discarded at the end of life of your
9080-MHE, 9080-MME, 9119-MHE, or 9119-MME server. The time-of-day batteries are located in sockets
on the real time clock battery cards in locations Un-P1-C3 and Un-P1-C4 of the system control unit.
To remove the time-of-day batteries, complete the following steps:
1. Pull the latching handle (A) out to unlock each real time clock battery card. Pull the real time clock
battery cards (B) out of the system control unit. See Figure 1 on page 2.
2. Remove the time-of-day batteries (C) from the socket on each real time clock battery card. See
Figure 1 on page 2.
© Copyright IBM Corp. 2014, 2015
1
Hide quick links:
Advertisement
Table of Contents
