Trigger Controls - Access Interfacing Solutions LSR110 Product Manual

A.3

Trigger controls

To set the device status to activate the 'read' lights on the device, send an HID output report with
the following structure:
Byte 7
0 Report ID = 4
1 -
Note: You can only use 'trigger' and 'untrigger' commands in Interactive mode. 'Good Read' and
'Bad Read' indicator controls are only available in Host or Interactive modes.
Page 28 of 33
6 5
Activate Activate
'Good 'Bad
Read' Read'
light light
(Green) (Red)
Bit
4 3
- -
2 1
Initiate Prevent
barcode barcode
read read
(trigger) (untrigger)
Copyright © Access-IS 2020
0
-