Oven Light; Oven Door; Removing The Oven Bottom - Whirlpool W10110357 Use And Care Manual

BROILER PAN AND GRID (on some models)
Cleaning Method:
Mildly abrasive cleanser:
I
Scrub with wet scouring pad.
Solution of cup (125 mL) ammonia to 1 gal. (3.75 L) water:
I
Soak for 20 minutes; then scrub with scouring or steel-wool
pad.
Oven cleaner:
I
Follow product label instructions.
Porcelain enamel only, not chrome
Dishwasher
I

Oven Light

The oven light is a standard 40-watt appliance bulb. It will come
on when the oven door is open. When the oven door is closed,
press OVEN LIGHT to turn on the light.
Before replacing, make sure the oven and cooktop are cool and
the control knobs are off.
To Replace:
1. Unplug range or disconnect power.
2. Turn bulb counterclockwise to remove from socket.
3. Replace bulb.
4. Plug in range or reconnect power.

Oven Door

For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open the oven door. Insert hinge pins, included with your
range, into both hinge hangers. Do not remove the pins while
the door is removed from the range.
2. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
3. Pull door straight up, then toward you. Do not remove hinge
pins until the door is replaced on the range.
12
To Replace:
1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
2. Hold oven door so that the top edge of each door slot is
horizontal. Insert door hinge into the hinge slots.
3. Tilt top of door toward range. Insert bottom door hinge notch
down onto front frame edge.
4. Open the door completely and remove the hinge pins. Save
hinge pins for future use.
5. Close the door slowly to assure door side panel clearance
and proper hinge engagement.

Removing the Oven Bottom

The oven bottom can be removed for standard cleaning of the
oven.
Before cleaning, make sure the oven is completely cool.
To Remove:
1. Remove the oven racks.
2. Place fingers in the slots in the bottom panel.
3. Lift the rear of the panel up and back.
The lip at the front of the panel should clear the front frame of
the oven cavity.
4. Lift the bottom up and out.
To Replace:
Reverse the steps above.
A
A. Lip