Vivotek IP7133 (WIRED) User Manual page 6

Privacy button network camera

Hide thumbs Also See for IP7133 (WIRED):

Table of Contents

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Hardware Reset

ETHERNET

1 2 3 4

RESET

Reset button

Status LED

There is a reset button on the back cover of the Network Camera� It is used to reboot the

Network Camera or restore the Network Camera to factory default� Sometimes rebooting the

Network Camera could set the Network Camera back to normal state� If the problems remain

after rebooted, restore the Network Camera to factory default and install again�

Reboot: Press and release the reset button� The status LED will blinks in red�

Restore: Press the reset button continuously until the status LED blinks in red and green

simultaneously� Note that all settings will be restored to factory default�

6 - User's Manual

Table of Contents

Need help?

Do you have a question about the IP7133 (WIRED) and is the answer not in the manual?

Ip7134