1. Manuals
  2. Brands
  3. Viking Range Manuals
  4. Ventilation Hood
  5. 5 Series
  6. Use & installation manual

Viking Range 5 Series Use & Installation Manual

Rear downdraft ventilators
Hide thumbs Also See for 5 Series:
Table of Contents

Advertisement

Quick Links

USE / INSTALLATION GUIDE
5 Series
Rear Downdraft Ventilators

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 5 Series and is the answer not in the manual?

Questions and answers

Related Manuals for Viking Range 5 Series

Summary of Contents for Viking Range 5 Series

  • Page 1 USE / INSTALLATION GUIDE 5 Series Rear Downdraft Ventilators...
  • Page 2 MODEL WIDTH BLOWER (purchased separately) VDD5300/CVDD5300 30" W. VDVI600 Interior or VDVE900 Exterior VDD5360/CVDD5360 36" W. VDVI600 Interior or VDVE900 Exterior VDD5450/CVDD5450 45" W. VDVI600 Interior or VDVE900 Exterior, VDVE1200 Exterior VDD5480/CVDD5480 48" W. VDVI600 Interior or VDVE900 Exterior, VDVE1200 Exterior READ AND SAVE THESE INSTRUCTIONS WARNING WARNING...

  • Page 3: Plan The Ductwork

    CONTENTS PLAN THE DUCTWORK These parts are included with your downdraft housing: 1 - Parts Bag 1 - Trim Kit HOUSING 4 - Support Legs 1 - Electrical Panel 2 - Support Brackets FLEX PLANNING BLOWER Due to its fl exible design, this downdraft system can be used to ex- haust airborne contaminants when cooking with a variety of gas or electric cooking appliances - including cooktops, rangetops, slide-in ranges and free-standing ranges.
  • Page 4 PLAN CABINET CUTOUTS PREPARE THE DOWNDRAFT CAUTION: FRONT PANEL COVER BEFORE CUTTING HOLE IN CABINET FOR DUCTWORK, check for interference with fl oor joists, wall studs, electrical wiring, or plumbing. CLAMP CHANNEL (4-6) HEX NUTS Electrical panel can be mounted remotely.
  • Page 5 8" OR 10" ROUND REMOTE DISCHARGE SLIDE PLATE (Purchase Separatly) CHANNEL COVER PLATE COVER UPPER PLATES SUPPORT BRACKET LOWER FRONT CHANNEL PANEL Flex Blower shown installed. Installations using FLEX BLOWER (in remote location) or REMOTE BLOWER only: 4. Use the REMOTE DISCHARGE PLATE and determine its LONG OR location on FRONT PANEL.
  • Page 6 RECTANGULAR DISCHARGE COVERS This Front Panel remains in place. Installations where ELECTRICAL PANEL needs to be Installations ducting through left, right or rear only: mounted in a remote location only: (Requires purchase of 2" x 19" to 8" or 10" round transition 6.
  • Page 7 CUT COUNTERTOP OPENING 1. Lay out and cut the cooktop cut-out far enough FORWARD so downdraft will fi t behind it. 2. Set cooktop in place and slide it as far forward as possible without exposing an gaps. Center and square it with edges SCREW of countertop.

  • Page 8: Install Ductwork

    INSTALL DUCTWORK Installations using REMOTE BLOWER only: CAUTION: All electrical wiring should be done by a CAUTION: BEFORE CUTTING HOLE IN CABINET qualifi ed person(s) in accordance with all applicable FOR DUCTWORK, check for interference with fl oor codes and standards. joists, wall studs, electrical wiring, or plumbing.
  • Page 9 INSTALL FINISH TRIM INSTALL COOKING APPLIANCE 1. Align the cooking appliance with downdraft and fasten ap- SCREW pliance in place following appliance instructions. Note: Accurate alignment of cooking appliance and downdraft is necessary to ensure that there is no interference when air vent FINISH is raised and lowered.
  • Page 10 USE AND CARE Servicing WARNING: Always disconnect electric power sup- It may be necessary to remove the downdraft blower system from ply before cleaning and/or servicing unit. the cabinet in order to service components such as the blower motor or air vent mechanism. Always turn the downdraft blower on before you begin cooking to establish an air fl...

  • Page 11: Operation

    OPERATION 4-Speed Fan Speed Control 4-Speed Fan Speed Control Press + button to increase fan speed. Press - button to decrease fan speed. After maximum speed is reached, press + button once more to turn off fan. 2-Level Task Light 2-Level Task Light Press once for LOW setting.

  • Page 12: Warranty

    To obtain warranty service, contact an authorized Viking Range, LLC service agent, or Viking Range, LLC 111 Front Street, Greenwood, Mississippi 38930, (888) 845- 4641. Provide model and serial number and date of original purchase or closing date for a new construction. For the name of your nearest authorized Viking Range, LLC service agency, call Viking Range, LLC.

This manual is also suitable for:

Vdd5300Cvdd5300Vdd5360Cvdd5360Vdd5450Cvdd5450 ... Show all

Table of Contents