Table of Contents
Advertisement
Solutions to common problems
Before you call for service, review the following list. It may save you time & expense. The list includes
common occurrences that are not the result of defective workmanship or materials in this appliance.
Problem
Solution
Oven control
• Electronic control has detected a fault condition. Push CANCEL pad to clear
beeps and
the display and stop the display from beeping. Reprogram the oven. If a fault
displays an F
reoccurs, record the fault number, push the CANCEL pad and contact an
error code.
authorized servicer.
Installation
• Place oven rack in center of oven. Place a level on the oven rack. Contact
installing agent if rack and cabinet cutout flooring are not level.
• Kitchen cabinet misalignment may make range appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
• When the range is first plugged in, or when the power supply to the oven has been
Entire range does
interrupted, the display will flash. The range cannot be programmed until the clock
not operate
is set.
• Be sure electrical cord is securely connected into the electrical junction box.
• Cord/plug is not installed and/or connected. Cord is not supplied with range.
Contact your dealer, installing agent or authorized servicer.
• Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug. Replace cord/plug.
• Controls are not set properly. See instructions to set the controls.
• House fuse has blown or circuit breaker has tripped immediately following
installation.
• House fuse may not be fully engaged. Check fuse and screw or engage circuit
breaker securely.
• Burned-out or loose bulb. Follow the instructions under Oven Light to replace
Oven light does
or tighten the bulb.
not work
• Make sure the oven door is closed.
Self-cleaning
• Make sure you have removed the oven racks and the oven rack supports from
cycle does not
the oven.
work
• Controls not set properly. Follow instructions under "Using the Self-Clean
Feature".
Poor cooking
• Many factors affect baking results. See baking for hints, cause and corrections.
results
See Adjusting Oven Temperature.
• Adjust the recipe's recommended power levels or cooking times.
• Cookware is too lightweight or warped. Use heavier quality cookware so foods
being prepared may cook more evenly.
• Excessive spillovers in oven. For example this will happen for pie spillovers or
Flames inside
large amounts of grease left on the oven bottom. Wipe up excessive spillovers
oven or smoking
before starting oven. If flames or excessive smoke are present see "About
from oven vent
broiling" in the Setting Oven Controls section.
Questions or for service call:
Before you call
1-877-4ELECTROLUX
(1-877-435-3287)
53
Advertisement
Table of Contents
