Signal Searching; Selecting The Aspect Ratio; Temporarily Blanking The Screen - ViewSonic PJ510 User Manual

Signal Searching

Press the SEARCH button
1
Cycles through input signals, displaying the images of retrieved signals. If no signal is found, it
returns to the signal that was selected before the search was initialized.
NOTE:
• May not function properly with some input signals.
• The signal searching function takes about 10 seconds to display an image.

Selecting The Aspect Ratio

Press the ASPECT button
1
RGB input
At RGB input, selecting an aspect ratio may display the message "SYNC IS OUT OF
•
RANGE". In this case, please select one of other aspect ratios.
VIDEO, S-VIDEO, COMPONENT VIDEO input
At a COMPONENT VIDEO input of 16:9 Hi-Vision of 1125i (1035i/1080i)/750p. only 16:9
•
can be selected.
When the 4:3 is selected under the SCREEN TYPE item of the OPTION menu, WIDE and
•
ZOOM cannot be selected.

Temporarily Blanking The Screen

Press the BLANK button
1
The input signal screen is shut off, and a blank screen appears. You can set the blank screen using
the menu (from the SCREEN menu, select BLANK).
Press the BLANK button again to remove the blank screen, and return to
the input signal screen.
NOTE:
The temporary blank function will automatically finish if any button of the projectior is pressed, if
there is a change in the input signal's state and or if the following functions are pressed on the remote
control. (STANBY/ON, SEARCH, RGB, VIDEO, BLANK, AUTO, VOLUME, MUTE, POSITION
OR MENU button.)
ViewSonic PJ510 20