Searching An Input Signal; Selecting An Aspect Ratio - ViewSonic PJL9371 User Manual

Searching an input signal

1.
Press the SEARCH button on the remote control.
The projector will start to check its input ports as below in
order to find any input signals.
When an input is found, the projector will stop searching
and display the image. If no signal is found, the projector will
return to the state selected before the operation.
COMPUTER IN 1  COMPUTER IN 2
VIDEO

● While the ON is selected for the AUTO SEARCH item in the OPTION menu,
the projector will keep checking the ports in above order repeatedly till an
input signal is detected.

Selecting an aspect ratio

1.
Press the ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
 For a computer signal
NORMAL  4:3  16:9  16:10
 For a video signal, s-video signal or component video
signal
4:3  16:9  14:9
 For no signal
4:3 (fixed)
● The ASPECT button does not work when no proper signal is inputted.
● The NORMAL mode keeps the original aspect ratio setting.
ViewSonic
S-VIDEO COMPONENT (Y, Cb/Pb, Cr/Pr)

7
Operating
SEARCH button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
AUTO
ASPECT SEARCH BLANK
PAGE VOLUME
MAGNIFY FREEZE
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON
MUTE
1 2
POSITION MENU
ENTER
ESC RESET
ASPECT button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
AUTO
ASPECT SEARCH BLANK
PAGE VOLUME
MAGNIFY FREEZE
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
POSITION MENU
ENTER
ESC RESET
PJL9371