Searching An Input Signal; Selecting An Aspect Ratio; Adjusting The Zoom; Adjusting The Focus - ViewSonic PJ400-2 User Manual

Searching an input signal

1.
Press the SEARCH button on the remote control.
The projector will begin to check its input ports in order
to find any input signals.
Then when an input is found, the projector will stop search-
ing and display the image. If no signal is found, the projec-
tor will return to the state selected before the operation.
RGB  S-VIDEO  VIDEO

Selecting an aspect ratio

1.
Press the ASPECT button on the remote control.
Each time you press the button, the projector switches the modes for aspect
ratio in turn.
 At a RGB signal
NORMAL  4:3  16:9
 At a video signal /no signal
4:3  16:9
● The NORMAL mode keeps the original aspect ratio of the signal.
● At a HDTV component video signal of 1125i (1080i) or 750p (720p), only 16:9
mode can be selected.
● Performing the automatic adjustment initializes the aspect ratio setting.
Adjusting the zoom (magnifying power)
1.
Press the ZOOM +/- button on the remote control.
A dialog will appear on the screen to aid you in adjust-
ing the zoom.
2.
Use the ZOOM buttons +/- to adjust the zoom.
To close the dialog and complete this operation, don't
perform operation for a few seconds.

Adjusting the focus

1.
Use the focus ring to focus on the picture.
Operating
STANDBY/ON
SEARCH
VIDEO RGB
BLANK
ASPECT AUTO
MAGNIFY HOME PAGE UP VOLUME
ON
END PAGE DOWN MUTE
OFF
FREEZE KEYSTONE
POSITION MENU
ENTER
ESC RESET