Lights And Printer Status - Epson EcoTank ET-1110 Series User Manual

User's Guide

Lights and Printer Status

When an error occurs, the light turns on or flashes. Details of the error are displayed on the computer screen.
: On
: Flashing
Light Situation
Initial ink charging may not be complete.
No paper is loaded or more than one sheet
has been fed at a time.
A paper jam has occurred.
When the power is on or flashing
❏ The printer was not turned off correctly.*
❏ Because the printer was turned off while
operating, the nozzles may have dried
and clogged.
* The power was turned off with a power
strip or breaker, the plug was pulled out of
the outlet, or an electrical failure occurred.
When the power is off
The printer has started in recovery mode
because the firmware update failed.
Printer Basics
Solutions
See the Start Here poster to complete initial ink
charging.
Load paper and press the
Remove the paper and press the
If the paper jam error continues after removing the
paper and turning the power off and on again, paper
may remain inside the printer. Load A4 size paper in
the rear paper feed, and then press the
remove the paper inside. Load paper in the portrait
direction.
If the error cannot be cleared, contact Epson support.
❏ After clearing the error by pressing the
we recommend performing a nozzle check. Cancel
any pending print jobs.
❏ To turn off the printer, make sure you press the
button.
Follow the steps below to try to update the firmware
again.
1. Connect the computer and the printer with a USB
cable.
2. Visit your local Epson website for further
instructions.
13
button.
button.
button to
button,
P