Operation Notes; General Cautions - Ricoh VT2100 Series Operating Instructions Manual

OPERATION NOTES

OPERATION NOTES

General Cautions

Make sure to make a few trial prints to check the image position because the
image position of the trial print might not correspond with that of the original.
The image position of the prints might slightly change when the printing speed
is changed while printing.
The leading edge of the prints might become stained if the edge touches the
image of prints on the paper delivery table. In this case, remove paper from the
paper delivery table.
When performing duplex or multicolored printing, leave the printed paper for a
while before the next printing in order to let the ink dry on the printed paper. If
this is not done, feed roller marks will appear on the print image.
If the machine is not used for a long period, the image density might decrease
because the ink on the drum might dry. Make extra prints until the image den -
sity recovers.
If the machine is not used for a long period, master misfeed might occur be -
cause the ink on the drum might dry. In this case, remove the old master from
the drum. See page 146.
The paper exit pawl might contact the printing paper and cause black lines on
the prints. In this case, increase the printing speed or make a new master with
lighter image density mode.
The first print paper might not be delivered completely. In this case, remove it
by hand before resuming printing.
If you print on thick paper with slow speed, paper might not be delivered com -
pletely. In this case, increase the printing speed.
The top sheet might remain between the feed rollers when you press the
Lower key to lower the paper feed table. In this case, remove the top sheet.
The ink of the print on the paper delivery table might stick to the back side of
the next print. In this case, increase the printing speed.
When the machine is used in low temperature conditions, the image density
might decrease. In this case, increase the room temperature or slow the print -
ing speed down to step 1 or 2.
The image density varies according to the printing speed and the room tem -
perature. So, adjust the printing speed or increase the room temperature.
158