detergent/care product you are using,
the water hardness and/or the degree
of soiling.
Adjusting the basic dosage
Press and hold ‰ i-Dos and/or  i-
1.
Dos for approx. 3 seconds.
The basic dosage setting will be
displayed.
Change the setting using: ˜/~
2.
To exit setting mode, press and hold
3.
‰ i-Dos and/or  i-Dos for approx.
3 seconds or wait approx. 10
seconds.
Notes
The changes are applied to all
■
programmes in which dosing is
possible.
The changes are saved until the next
■
time they are changed and are
retained even after the appliance has
been switched off.
Filling the dispensers
Notes
See the instructions in chapter
■
~ "Before setting up i-Dos"
on page 31
If ¨ or M flashes, fill the relevant
■
dispenser. ~ Page 31
Fill the dispensers as follows:
Pull out the detergent drawer.
1.
Open the dispenser lids.
2.
Intelligent dosing system
Pour liquid detergent and fabric
3.
softener into the relevant dispensers.
Notes
– Do not fill the dispensers above
the max. mark.
– Follow the instructions in
chapters ~ "i-Dos Setting the
dosage" on page 32 and ~ "i-
DosSetting the content of the M/
¨ dispenser" on page 32.
Close the dispenser lids.
4.
To prevent the detergent
Note:
drying out or drying up, do not leave
the dispenser lids open for a long
period of time.
Push in the detergent drawer.
5.
en
33