Friedrich ZoneAire PDE07R3SG Installation And Operation Manual page 30

New Construction Accessories
PDXDAA LATERAL DUCT ADAPTER Attaches to the Friedrich PTAC/PTHP unit to di-
rect up to 35% of the total airflow to a second room. The unit-mounted duct
plenum features a front-mounted aluminum grille that has two positions
to provide the most optimal air direction. The air may be directed to either
the left or the right of the unit through the supplied 3
plenum. Plenum may be cut to length by the installer. Kit includes duct
plenum, front grille, 47" duct extension, duct discharge grille, duct end cap
and all necessary mounting hardware.
PDXDEA
LATERAL DUCT EXTENSION Additional 3
use with the LATERAL DUCT ADAPTER. A maximum of 3 duct exten-
sions total may be used. Note: Ducted airflow is reduced as duct length is
increased.
PXSBA DECORATIVE SUBBASE Provides unit support for walls less than six inches
thick. Includes leveling legs, side filler panels and mounting brack-
ets for electrical accessories. Accepts circuit breaker, power disconnect
switch, or conduit kit.
PXSB ELECTRICAL SUBBASE Provides unit support for walls less than six inches
thick. Includes leveling legs, side filler panels, mounting brackets, a plug-
in receptacle and field-wiring access. The subbase also includes elec-
trical knockouts for a power disconnect switch or circuit breaker.
PXSB23020
PXSB23030
PXSB26515
PXSB26520
PXSB26530
RT6 DIGITAL REMOTE THERMOSTATS
RT6P
RT6 Wired single stage cool, single stage heat for PDE models or single
stage cool, dual stage heat for PDH model thermostat features high/low
fan speed switch. Thermostat is hard wired and can be battery powered or
unit powered. Features backlit display and multiple configuration modes.
For use on Friedrich PTACs and Vert-I-Paks.
RT6P Wireless single stage cool, single stage heat for PDE models or sin-
gle stage cool, dual stage heat for PDH model thermostat features high/
low fan speed switch. Thermostat is hard wired and can be battery pow-
ered or unit powered. Features backlit display and multiple configuration
modes. For use on Friedrich PTACs and Vert-I-Paks.
WRT1 WIRELESS DIGITAL REMOTE THERMOSTAT Single stage cool, single
stage heat for PDE models or single stage cool, dual stage heat for PDH
model thermostat features high/low fan speed switch. Thermostat is
wireless and is battery powered. Features backlit display and multiple
configuration modes. For use on Friedrich PTACs and Vert-I-Paks.
REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten escutch-
PDXRTB
eons that can be placed over the factory control buttons when a remote wall
mounted thermostat is used. The escutcheon directs the guest to the wall
thermostat for operation and retains the LED window to display error codes
and diagnostic information.
ENERGY MANAGEMENT THERMOSTATS
EMRT1
EMWRT1
EMRT1
Wired thermostat with occupancy sensor.
EMWRT1
Wireless thermostat with occupancy sensor.
EMOCT
Online connection kit.
1
/
2
Electrical Subbase - 230V 20A
Electrical Subbase - 230V 30A
Electrical Subbase - 265V 15A
Electrical Subbase - 265V 20A
Electrical Subbase - 265V 30A
EMRAF
Remote access fee.
1 / H" x 7 W" x 47" L
2
H" x 7" W x 47" L plenum for
EMRHCF
Remote humidity control fee.
30