Entering An Address With A Postal Code - Uniden TRAX353 Owner's Manual

Entering an address with a postal code

The current Sensis R15 map does not support Post Codes as
described in this section.
NOTE
All of the above address searching possibilities can be performed with
entering the postal code instead of the settlement name. Find below an
example with a full address:
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
, (Advanced mode).
2. By default, TRAX353 proposes the country/state and settlement
where you are. If needed, tap the button with the name of the
country/state, and select a different one from the list.
3. Tap the button with the name of the settlement, and enter the
postal code:
1. Start entering the postal code on the keyboard.
2. Get to the list of results:
• After entering a couple of numbers, the ones that are a
match appear in a list.
• Tap
appears automatically.
3. Pick the settlement from the list.
4. Enter the street name:
1. Tap
2. Start entering the street name on the keyboard.
3. Get to the list of results:
• After entering a couple of characters, the names that
match the string appear in a list.
(Simple mode), or
to open the list of results before it
.
How Do I Use It?
Page 55