Table of Contents
Advertisement
6. Shutter and Drive Settings
Changing the settings for [Single/Burst Settings], [Step] and [Sequence] in Auto
∫
Bracket
1
Select the menu.
>
MENU
2
Press 3/4 to select [Single/Burst Settings], [Step] or [Sequence] and then
press [MENU/SET].
3
Press 3/4 to select the setting and then press [MENU/SET].
[Single/Burst Settings]
[Step]
[Sequence]
•
You can take one picture at a time when set to [
•
You can continuously take pictures up to set numbers when set to [
•
Exit the menu after it is set.
•
When taking pictures using Auto Bracket after setting the Exposure Compensation value, the
pictures taken are based on the selected Exposure Compensation value.
Not available in these cases:
•
Auto Bracket is disabled in the following cases.
–
[Glistening Water]/[Glittering Illuminations]/[Handheld Night Shot]/[Soft Image of a Flower]
(Scene Guide Mode)
–
[Rough Monochrome]/[Silky Monochrome]/[Miniature Effect]/[Soft Focus]/[Star Filter]/
[Sunshine] (Creative Control Mode)
–
When White Balance Bracket is set
–
When recording motion pictures
–
When recording using the flash
–
When recording with the shutter speed set to [B] (Bulb)
–
When recording with [iHandheld Night Shot]
–
When [HDR] is set to [ON]
–
When using [Multi Exp.]
–
When [Simultaneous record w/o filter] of [Filter Settings] is set to [ON]
(P63)
[Rec] > [Auto Bracket]
[
] (single)
[
] (burst)
[3•1/3] (3 pictures)
[3•2/3] (3 pictures)
[3•1] (3 pictures)
[5•1/3] (5 pictures)
[5•2/3] (5 pictures)
[5•1] (5 pictures)
[7•1/3] (7 pictures)
[7•2/3] (7 pictures)
[7•1] (7 pictures)
[0/`/_]
[`/0/_]
].
200
].
Advertisement
Table of Contents
