Setting Master Unit's Flash Mode; Setting The Communication Channel; Wireless Id Settings; Ttl: Fully Automatic Wireless Flash Shooting - Godox Ving V350C Instruction Manual

Slave Unit Setting
MODE ZOOM SYNC SLAVE
SET

2. Setting Master Unit's Flash Mode

MODE ZOOM SYNC SLAVE
SET
MODE ZOOM SYNC SLAVE
SET

3. Setting the Communication Channel

If there are other wireless flash systems nearby, you can change the
channel IDs to prevent signal interference. The channel IDs of the
master unit and the slave unit(s) must be set to the same.
MODE ZOOM SYNC SLAVE
SET
SET

4. Wireless ID Settings

Change the wireless channels and wireless ID to avoid interference
for it can only be triggered after the wireless IDs and channels of the
master unit and the slave unit are set to the same.
Press the <MENU> button to enter C.Fn ID. Press the <SET> button
to choose OFF channel expansion shutdown, and choose any figure
from 01 to 99.
- 41 -
1
Long Press the <SYNC>
button for 2 seconds so that
< > is blinking. Turn the
Select Dial until the < > is
displayed on the LCD panel,
which means the slave unit.
1
Press the <SLAVE> Button to
c h o o s e t h e g r o u p f r o m
M/A/B/C. Then, press the
< MODE > Button so that the
master unit can work in OFF /
TTL / M flash mode. Choose
one of them as the flash
mode of master unit.
2
Press the <MODE> Button for
2 seconds to switch to Multi
mode.
1
Long press the <SLAVE>
Button for 2 seconds until the
channel IDs is blinking. Turn
the Select Dial to choose a
channel ID from 1 to 16.
2
Press the <SET> button to
confirm.

5. TTL: Fully Automatic Wireless Flash Shooting

Autoflash Shooting with One Slave Unit
MODE ZOOM SYNC SLAVE
SET
The slave unit might be out of order or fire an unwanted flash
due to the nearby wifi routers or other 2.4G equipments. If in
this case, please adjust the flash's channel or turn off the 2.4G
equipments.

6. M: Wireless Flash Shooting with Manual Flash

This describes wireless (multiple shooting) using manual flash. You
can shoot with a different flash output setting for each slave unit
(firing group). Set all parameters on the master unit.
MODE ZOOM SYNC SLAVE
SET
1
Master Unit Setting
● Attach a V350C camera
flash on the camera and set it
as the master unit. (Page 40)
● M/A/B/C can be set as
TTL mode independently.
2
Slave Unit Setting
● Set the V350C that to be
controlled as the wireless
slave unit. (Page 41)
● The slave unit can be set
as A/B/C.
3
Check the communication
channel
● If the master unit and
slave unit(s) are set to a
different channel, set them
to the same channel.
(Page 41)
4
Position the camera and
flashes
● Position the camera and
flashes as the picture
shows. (Page 43)
5
Check the flash operation
● Press the master unit's
Test Button< >.
● Then, the slave unit will
fire. If not, adjust the slave
unit's angle toward the
master unit and distance
from the master unit.
1
Setting the flash mode to
<M>
● Press the <MODE> Button
to set the flash to M mode.
2
Setting flash output
● Turn the Select Dial to set
the flash output of the
groups.
- 42 -